Wierd thrust washer problem....
Thread Starter
Junior Member
Joined: Mar 2002
Posts: 454
Likes: 0
From: east coast
Wierd thrust washer problem....
I have an engine(B18A) that has eaten a set of thrust washers once. I pulled the bottom end apart and replaced the crank as well as installed new thrust washers. The endplay was measured, and was within spec. The engine still makes the same "ticking/crunching" noise as before. All of the bearings are perfect, so I know that the noise isn't any type of knock.
The complete bottom end has been checked and reassembled, but the noise continues. I am about to pull it apart again to check the thrust washers. Any ideas on what would cause an engine to eat the thrust washers?
The complete bottom end has been checked and reassembled, but the noise continues. I am about to pull it apart again to check the thrust washers. Any ideas on what would cause an engine to eat the thrust washers?
Thread
Thread Starter
Forum
Replies
Last Post
ScorpioX
Honda Civic / Del Sol (1992 - 2000)
4
Jul 17, 2005 08:29 PM
adrianw
Honda Accord (1990 - 2002)
3
Nov 19, 2003 09:35 AM
