Here is my problem:

Ight i hooked a VAFC in my car today (00 Civic Coupe with JDM B16A Swap with ODB2-ODB1 conversion) now....

I soldered the wires where they were suppose to go and everything but everytime i shut the car off it resets and goes back to the orginial program....which was a 6 cyl...I need some input...help

Also when i set the Vtec points it doesnt like to change, just likes to go in at 5800, no matter how low or high i set it at...

Ive been told i need a constant 12v source and the ignition wires that i have hooked up are not constant, while that might be one solution, i still need some expertice on this subject...thanks guys

 

what is ur initailize setting on yes or no?


change it to no

welcome to HT

 

Ight i fixed the Settings problem but now i cannot figure out why my vtec points will not lower, and i am adjusting both the lo > hi setting and hi > lo settting...

 

is it on 4 cyl? increasing throttle??

 

yes all the initial settings are correct....