can someone tell me how to take out the rivets that are holding the tps to the throttle body? i want to put a new tps on thanks

 

dremmel, or just get a drill the rivets

 

use drill with bit just big enough to drill off tops of heads.

However, a lot of TP sensors used tamperproof bolts, not rivets. So you may want to try small hammer with chisel and lightly tap these heads in counterclockwise rotation to loosen them and then they should back out.

It's been a while since I have modified throttle body for replacing TPS so I could be wrong...

I mean I have slept since then.

 

file the head of the bolt/screw to a slot so you can unscrew the bolt/screw with a flat-head screwdriver

 

Dremel cut-off disc to cut a slot into the bolt/washer. Then use a standard screwdriver to remove them.

 

im going to use southsol and invtec's method thanks everyone damn i wish i had a dremel