I'm trying to install the front anti-swaybar for 96-00 civic by sus tech I cannot seem to fit the "adaptor bracket" and the "end assembly" at the correct position on the control arm. Spacer on the adapter bracket is too big to allow it to slided down far enough toward the tire end of the control arm. the "end assy," which connects the bar and the bracket, is angled so far that I'm afraid it'll break. instrucitons say it should be close to 90 deg. any suggestions? Hope this makes sense thanks

 

errm

pictures? I have a sway bar and it was a little rough getting on but not much

 

Is there any way you can get the pic of your set up? then i'll probably know how to put it together. or alternatively, have you seen any pics on the web? thanks

 

i just spoke with the customer rep, and she suggested shaving a little bit off either the control arm or the spacer. any comments?