I installed a set of Goodridge SS brake lines, and I made the mistake of using a standard (Not standard as in 5/16", but Normal style ended) wrenches rather than Flare Ended wrenches. Long story short I ended up rounding out the end of the Hard line that screws into the new Soft (SS) barke line....

I purchased a NEW hardline from my local Honda shop and I was wondering... How hard is it to "Shimmy" the Hard line into place while having the motor in, and pretty much everything there. We're talking about from the Proportioning Valve all teh way into the Passenger Side Front Wheel well, where the New Hard Line will meet the SS line.

ANy pics or advice???

THanks!!!

-George

 

You should be able to do it. I believe there is a grommet that the line goes through in the inner fender. Try popping that out to make more room, then reinstall when finished. Its not THAT tight in there. Good luck.

 

Yeah, i seen the grommet before, not a problem, I am just worried I might get caught up somewhere, and those hardlines break easily under pressure. Oh well, Here I go!!!!

Thanks