LS Vtec parts list
Thread Starter
Member
Joined: Oct 2001
Posts: 1,605
Likes: 0
From: Upstate, NY
LS Vtec parts list
I'm getting ready to build the bottom half of the engine as I do not have a head as of yet. Im using a B18 out of an 91 Integra LS. The swap will go into a 90 Civic hatch. I would like to upgrade the rods too.
If anyone knows a good web site with information on this please post it thanks.
If anyone knows a good web site with information on this please post it thanks.
Junior Member
Joined: Aug 2002
Posts: 235
Likes: 0
From: Grandview, TX, USA
Joined: Jun 2002
Posts: 301
Likes: 0
From: Dirty Jersey, USA
Re: LS Vtec parts list (ZC_CRX)
get a Z10 girdle, ARP rod bolts, ARP head studs...and upgrade the pistons...have it built by a reputible shop also with all new gaskets, seals, o-rings, bearings, so on and so forth...if you do it right the first time, you dont have to worry about problems in the near future
point of advice...i wouldnt rev it past 8k even with all the mods i listed
point of advice...i wouldnt rev it past 8k even with all the mods i listed
Thread Starter
Member
Joined: Oct 2001
Posts: 1,605
Likes: 0
From: Upstate, NY
Re: LS Vtec parts list (CC94B18)
I plan on using a block guard along with Eagle rods. Also I was planning on using a Mugen head gasket from www.kingmotorsports.com. Will this change the compression over a stock head gasket.
[Modified by ZC_CRX, 10:03 PM 1/28/2003]
[Modified by ZC_CRX, 10:03 PM 1/28/2003]
Thread
Thread Starter
Forum
Replies
Last Post
Eviltek1989
All Motor / Naturally Aspirated
9
Mar 21, 2010 05:09 AM
90 integra da
All Motor / Naturally Aspirated
16
Mar 12, 2010 04:19 PM
