I'm having issues with my ID 1000cc injectors, every time I want to put them in on the cushion it just wants to fall through it. Or if I carefully get them to sit in the cushion it makes my fuel rail too high to bolt it. Here's some pics to show what I'm dealing with and hopefuly some one can chime in. Oh and btw I got these injectors used from a member so if I am missing anything let me know.
Attachment 310477

 

Your going to want the rubber injector washer to sit past the o-ring. What do you mean by makes your fuel rail too high to bolt in? A picture of that would be much better than what you posted.

 

Sorry I was trying to do this from my phone but how I have it in the pic makes the fuel rail sit too high past the studs.
Is this what u mean by past the O ring

 

 

This does not work because when I put the fuel ra in it pushes the injector in and I don't like the idea if the O ring being past the cushion and get sucked in the motor

 

Bump

 

bump any one?

 

Had the same issue today when I swapped mine used the same rubber grommet and either sits up top or all the way in and wobbles, tomorrow im going to check for bigger size o ring, and info on yours ?

 

Frist off there is no need for the bottom o-ring. What you are missing is a collar that fits on top of the bottom seal. This collar keeps the seal from riding up on the injector. Hope this helps,

 

Where can this collar be purchased ? Thanks

 

We can't sell them to you because we are not vendors on this forum, however if you want I'll help you out and give you a set one car guy to another.