I pretty much have a brand new 70mm skunk 2 throttle body.. the throttle plate sticks inside which is creating my motor to rev out. while im stopping and driving? should i clean it? or sent it back to skunk 2? any suggestions?

 

Remove the air intake and rotate the throttle by hand to see if there is any obvious interference. Have you checked the throttle cable for free movement as well?

 

yeah the throttle cable is good. i drive the car and it gets stuck at like 3 - 4 grand. im going to take it apart and clean it tommorow. what else should i do?

 

Grease the Throttal spring, and the hindges on the throttl plate.

 

Most of the time its the plate its self ... you paid good money for it, so send it back there good with it they know that some of theme do this ... dont waste tour time ...

 

clean the throttle body, still getting stuck.. should i send it back to skunk 2?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by OneCrzySetup &raquo;</TD></TR><TR><TD CLASS="quote">clean the throttle body, still getting stuck.. should i send it back to skunk 2?</TD></TR></TABLE>

If it is not something obvious, send it back.

 

Its weird, i drive the car when i shift it, the throttle is fine, i give it alittle gas, and boom it sticks at like 4grand. i tap the gas again and the rpms go back down.. The trottle plate wasnt sticking at all when i cleaned it. not a clue what it could be.... someone said to greese the plate.. what kind of greese should i use?

 

Could your throttle cable or gas pedal be sticking? Are you using the stock throttle cable and throttle rotor? Post a picture of your setup showing the cable mount and rotor.

If you ran an ITR type throttle cable mount with a GSR throttle rotor (B18C1 throttle rotor is unique), it could be causing an issue.

 

your throttle plate. the two screws that holds in it place, loosen those and adjust the plate and tighten it down, doesnt hurt to put alittle red loctite on there.