full race all motor ???
Thread Starter
Honda-Tech Member
Joined: Dec 2001
Posts: 2,202
Likes: 0
From: connecticut
full race all motor ???
was wondering if any one in the ny/nj/ct area knows of a shop that will be custom crank work (weld/stroke) and deck plates..... i want to use GE for the sleeves though ......tia
Honda-Tech Member
Joined: Sep 2000
Posts: 5,276
Likes: 0
From: Sears Point, CA
Re: full race all motor ??? (dohcsideSi)
Take a look at the thread below from Vince at Golden Eagle
https://honda-tech.com/zerothread?id=211054
Interesting stuff that you remember 
Austin
[Modified by Austin, 3:08 PM 7/10/2002]
https://honda-tech.com/zerothread?id=211054
NHRA allows only a 3/4" deck plate but you can still build a 2.258 L B-series engine and maintain a 1.59 rod ratio
Austin
[Modified by Austin, 3:08 PM 7/10/2002]
Thread Starter
Honda-Tech Member
Joined: Dec 2001
Posts: 2,202
Likes: 0
From: connecticut
Re: full race all motor ??? (Austin)
Take a look at the thread below from Vince at Golden Eagle
https://honda-tech.com/zerothread?id=211054
[Modified by Austin, 3:08 PM 7/10/2002]
https://honda-tech.com/zerothread?id=211054
[Modified by Austin, 3:08 PM 7/10/2002]
thanks
i didn't see it on their site although i heard about it, i'll give them i call
Trending Topics
Thread Starter
Honda-Tech Member
Joined: Dec 2001
Posts: 2,202
Likes: 0
From: connecticut
Re: full race all motor ??? (Austin)
just got off the phone w/ vince not only do thier products rock so do thier employees for vince for taking the time to explain his products and services
for vince for taking the time to explain his products and services
Thread
Thread Starter
Forum
Replies
Last Post
loudog18
All Motor / Naturally Aspirated
3
Sep 10, 2003 06:30 PM