i'm swapping out my aftermarket header for an oem replacement manifold and one of the fasteners rounded out, i'm just looking for suggestions on getting it off without damaging the head or the stud. i tried vise grips but i don't have a whole lot of clearance, maybe 1.5" horizontal.

if it helps it's a d16y8 so there're 9 bolts holding the manifold. the one that rounded out is the third from the left or the second one if you're just counting the bottom. thanks.


EDIT:


nevermind, i just cut the whole damn stud off.


Modified by Mandark06 at 1:47 PM 6/5/2008