CODE 10 (IAT) ON B20VTEC SWAP!!
#1
Member
Thread Starter
CODE 10 (IAT) ON B20VTEC SWAP!!
This is the only code i cant get rid of....i've replaced the old sensor because it was like burnt. now i just installed a new IAT, but the code still shows up...i've even reset my ecu no luck....any idea's? If this helps im using a 98ex harness w/ a gsr head and jdm p30 ecu.
#4
Re: CODE 10 (IAT) ON B20VTEC SWAP!! (SpoonEk253)
You probably have the wrong connector pluged into the IAT! Been there done that. Check the sensor again and check the wire colors with a schematic. I'd put money on it that you have the wrong connector plugged into the IAT.
#5
Member
Thread Starter
Re: CODE 10 (JamesParker)
the colors on the wires that i plug'd into the IAT is black/green and the colors i got in my IACV is yellow/black, then the colors i got goin to the black cansiter is black/blue....im pretty sure they are the right ones....there arent any other plugs that can reach that far or fit.
Thread
Thread Starter
Forum
Replies
Last Post
silentblackhat
Honda Civic / Del Sol (1992 - 2000)
6
05-01-2005 04:41 PM