im putting in a obd2 ls in my ek coupe and i was woundering if i can use my stock mounts or the ls mounts and my stock wiring harness... also can i use the ls rear bracket or do i need the si 99-00 rear bracket

 

your gonna have to use all 99-00 civic si engine mounts even the rear bracket deff, and as for the engine harness what model do you have, but if you want a direct wire up use also a civic si and not use the vtec wires and in the near future you might wanna go ls/vetc then you are ready

 

its a dx.. so i cant use the ls wiring harness or my stock one?

 

you should be able to use a ex harness and just extend some wires, and youo should be fine

 

ok but i couldnt use the ls rear bracket? and wat eles do i need.. i have the motor tranny axles, shift linkaage, ecu, starter and thats it

 

no the ls will not woork i believe it is little longer

 

you can use the stock dx harness, i think the only sensor you will have to extend is the purge valve solenoid. and the crank fluctiation sensor thing on the oil pump doesnt directly wire up.


99-00 si or 94+ integra shift linkage, 99 si T bracket and drivers side bracket (the one that bolts directly to the block behind the timing belt cover. the rest of the mounts are from your dx