Building up a Z6/Y8 with PM7 pistons overbored .5 with a Y8 head by alaniz . The head is milled .010" and i really wanted to get 12:1 compression as close i could without venturing too close to 13:1. The only headgasket around for D series that would give me this was this Apex 814-H102 but for those of you who are bored try google searching that model number and you find this page http://www.apexi.co.jp/product....html So i call around and no one can get it or knows what it is. Even apexi is confused a little bit. Finally i call an Apex wholesale dealer and they find one. I know Builthatch has this gasket on his setup but as far as i know that's it. Anyway here's the instruction booklet that came with it...





Can anyone tell me what it says!?

Vince

 

Pic too small, can't see the letters clearly.

 

Lol, you're not missing out on anything! Unless of course you can read Japanese.

Should i be worried about those Caution signs?