ok, here's what i'm trying to do,

I'm trying to use a base map off of hondata romeditor's program and changing the vtec and rev limiter's point. then saving the bin and writing it to the eprom using the pocket programmer.

Everytime i tried this, i get a cel "0" and rev cuts out at 4k.

So i assumed that the bin wasn't being written to the eprom. I copied a skunk2 proggy using the pocket programmer and wrote that bin to the chip. It runs fines, which confirms that the pocket programmer works and it's being written.

So my question is, what am i doing wrong? Even when trying to write a stock map off of the rom editor's program, but get the same problem.

thanks for the help