Hey I was wanting to find out if I was to get sleeves from either darton or golden eagle can I have a stock bore size? or do you have to have them bored over. If I have pistons that fit a stock bore now can I still use these when I get my block sleeved?

thanks

 

?????????????

 

Definately, I wouldn't go with GE sleeves. I've seen few sleeves sink and that is enough to say, "No" to GE.

I believe you can keep it at stock bore size.. Why not?

 

RS Machines has great turn around time and you can use your stock bore...

 

Don't start the GEM sleeves sink crap again I know people making 500+WHP that have been using GEM sleeves for quite some time now. I have talked to Vince, Rob and Ted at GEM for a while too. I have had resleeving, line boring, honing and allot of other stuff done by them.

 

you can get the sleeved block to a stock bore of 81mm if you want. just have to specify what you want.
$880 for sleeves with hot tank, decked, honed, bored...
ready to go and complete the installation of the internal parts.