ok 93 ls bottom end re-building for all motor N/A
.20 bored over
eagle forged esp rods
eagle pistons 10.5:1 compression street/strip

if i bore the engine.....do i still need to hone/sleeve it??
if you have suggestions please leave them cause i want to get the best set up i can

 

ttt

 

I belive you need to hone it to get the cros hatch lines in there (whatever they are called.) as for sleeving..No..since you are boring. As long as stock one is fine.

 

you know anything bout crower cams?

 

You absoultley need to hone it. S;eeving is not necessary. Although if you are already in there I would consider getting sleeves and running a much larger bore 83mm - 84mm. This would give you close to 2 liters.

 

ok....if i am goin with like srp pistons 81.25 mm 10.5:1 compression with eagle rods and then boring the motor like .20 and then honing it will i be ok?? will i be done with the bottom end besides the piston rings?