if someone knows the size of the fitting that goes on the back of the block, can you help me out and tell me what size it is. im in the army and am able to get a hold of all kinds of fittings. thanks

 

are you talking about for a catch can?

 

http://i267.photobucket.com/albums/i...DSC_0011-1.jpg

 

what size tool is that used to remove the factory fitting?

 

i believe its a 14mm hex

 

I bought a bunch of all thread couplings and used one that fit snug (I tapped it in with a hammer) then put a wrench on it and gave 'er hell.

 

Yeah, it's a big hex.

What I did was get a bolt in which the head fits the hex opening. Then thread two nuts on it and lock them together on the bolt. Then you can just use those and the head of the bolt to back the plugs out of the block.

 

yea im talking about for a catch can. im not talking about the hex key size that i need. im talking about the actual fitting that goes in the block. just wanted to know if it was like a specially made fitting or if it was something i might find here.

 

That works wonders as well.
I bought my block fitting kit thru Go-Autoworks. I bought the full catch can setup so the block fittings and plugs came with it.

Link: http://www.go-autoworks-store.com/gocaca.html

 

i used the fitting from B&R
http://www.brfittings.com/index.php?...&product_id=54

they also make one with a -10an fitting
http://www.brfittings.com/index.php?...&product_id=56

 

the size of the fitting is M28 to -10 an

 

There's a couple threads online about using some factory fitting from honda for a barb nipple. That's what I did, but I couldn't tell you the part numbers off the top of my head.