DSM turbos vs Garrett GT ball bearing turbos
Is there a difference in transient response and spool between td04 and td05 turbos (14b. 16g etc) and garrett gt2560r gt28rs and all the other turbos?
I am doing a Twin setup on my 1jz and I can go either Mitsubishi or Garrett t2's . just looking for the better route.
I am doing a Twin setup on my 1jz and I can go either Mitsubishi or Garrett t2's . just looking for the better route.
Wow. that is going to take a lot of writing. Have you checked this place out yet, to do a little self-education between the two platforms? This may help..
Now, there's a lot there, but you need to actually READ IT, and understand that there are some nuances and subtle differences between these platforms to help make a decision.
http://www.stealth316.com/2-3s-compflowmaps.htm
Otherwise, that's just too long for someone to just "spell it out" on a forum like this. No one would have the time, really.
Now, there's a lot there, but you need to actually READ IT, and understand that there are some nuances and subtle differences between these platforms to help make a decision.
http://www.stealth316.com/2-3s-compflowmaps.htm
Otherwise, that's just too long for someone to just "spell it out" on a forum like this. No one would have the time, really.
Thread
Thread Starter
Forum
Replies
Last Post
MiamiVR6T
Forced Induction
3
Feb 25, 2010 10:30 PM
markvqwerty
Forced Induction
9
Jan 5, 2005 07:45 AM
boosted_dc2
Forced Induction
13
Sep 5, 2003 02:01 PM





