What does this connect to?



it is the oild feed line from the turbo I know it goes to the block but what is the name of the fitting it connects to?


Also are these holes suppose to be empty?

 

bump

 

the oil pressure sending unit is on that tee fitting.

it looks like that turbo is water cooled. so you have to hook up coolant lines to it.

 

thats the stock oil pressure sending unit.

If a turbo has 2 ports both are for oil, if a turbo has 4ports it has 2 for water and 2 for oil.

you need an hose ends to hook up to that oil tee to the turbo, most likely a -3 or -4 fitting.

 

where do I hook up the water lines?

 

throttle body

 

does anyone have any pics of were to hook the lines up, because im not sure were

 

anyone? what throttle body lines do I tap into?

 

the only ones with coolant, on the bottom of the throttle body.

 

https://honda-tech.com/forums/forced-induction-16/ball-bearing-turbo-coolant-lines-2543099/

https://honda-tech.com/forums/forced-induction-49/turbo-coolant-line-kits-w-black-fittings-2014711/

those should help

 

I think im going to run the turbo with out the coolant/water lines. Can I just bolt them up or can I leave them open

 

anyone?

 

IMO, you should NOT run that turbo without using coolant.
It was designed for it, so i wouldn't be surprised if it calved real soon without it's proper application. You just need to plumb it in line with your Throttle Body coolant hose....
Run a coolant hose to your turbo coolant inlet..... and then run the outlet side to the original inlet on the Throttle body...
If that is too hard to figure out, then maybe you better be getting someone to give you a hand with this install. no offence...
Good Luck!!!