Ok we start my motor yesterday...everything is fine except the code 7...whitch is the TPS...i ran 3 motors with my OEM b18c TB and this TPS and never had any kind of problem with it...but now i have a skunk2 68mm TB and the car run's like a subaru So i wanna know at what exact # we need to adjust it??? he was at 0.28 at the start-up...after a friend of mine told me it was suppose to be at 0.50 when the butterfly is closed, is that correct???

anyway i need to get the car on the road tonight so maybe someone can help me out figure this one out

Thanks guys!!!

 

~.45v closed
at least 4.5V open

 

first he was at 0.28...and after we put it to 0.50 and the cell was still poping after 5 seconds...the RPM was steady at 1000rpm but the sound was like a subaru and the rpm had trouble to go up...is this what the code 7 should be???

 

CEL 7 is for a TPS, get it calibrated, reset the ecu, then let us know how it runs, oh and make sure you didn't swap the TPS and Map sensor sockets.

 

even if you did swap them, it would not throw a code for either one.

 

we didnt mix up any sensors...ill put it to 0.45 and after ill reset the ECU and well see Thanks for the help guys