I cannot remove the pulley's from neither my h22 or f22 water pump's. This is my final step to completing my g22 and its becoming annoying. I have tried three different pullers but no luck. Any suggestions, I'm assuming a machine shop could do it if I could find one around here. Thanks

 

I dont belive the pullies are removable. You replace the pump as a whole...

 

take a pulley puller....

place the center punch on the main cneter piece and slowly pull the outside t-belt gear off the water pump....do the same for both of you pumps...being the h22/f22 you can use a shitty h22 waterpump so they are very easy to come by cause all you using is the gear...not the bearings and such...so just make sure you have a good f22 water pump and youll be set.

From prelittlelude's g22 build. It has a pic but it wont load up and I followed what they describe but no luck.