I've taken her to the track a couple of times and only managed a 15.3 @ 94 mph as my best time (75 wet shot). My 60 ft. was a 2.5~2.6 on 16 inch rota subzero's and 205/45/16 Kumho's. My clutch is bad so in other words I baby it off of the line. I also, don't hit nitrous till deep into 2nd gear. With a new clutch/flywheel and some nitto's or bfg's, what do you guys think I can expect (yes, I'm a pretty good driver )

BTW my average times off of the bottle are usually between 16.0~16.2@82-85mph and my best is a 15.9@85~2.3 60 ft. all on balding Bridgestone RE730's.


[Modified by sando112, 4:38 PM 6/6/2002]

 

bottle
thats my opinion.

 

i say a mid to higher 14 with some good tires, i dont know if the bfgs will get you mid, but high 14's i can see , also with the clutch , that is key
what s you fuel pressure? jetting ? and bottle pressure? that will make a diff too , i had mine jetted too rich and killed my times tuff.
let me know that and ill tell you if your cool with fuel and **** . did you ever tune her on the dyno? what about timing where you at?

 

damn a dohc on juice, only 2-3 seconds slower!!!!!!!!!

Power to the SOHC!!!!!!!!!

 

so mista bone . when you gonna bring that beast to the tri state area for me to see it on the track you aint too far. i m still not believing those times.
etown , atco , or maple grove. let me know.

 

my times were in Cincy Ohio.

Either Edgewater (NHRA) or Tristate (IHRA).

You're on the wrong tristate.........

Now this was with a bone stock setup. Think what I could do if I built it?????

 

either atco , etown , maple grove?
trie state, nj/pa/ny

 

Every time I see civics run at the track it makes me regret I bought my teg. Don't get me wrong, I love my car. It's just that civics have a such a huge weight advantage. I see most weighing in at 2100-2200 lbs (with the drivers). I weighed my car last night and with me in it--2780lbs. That's a loooot of weight to make up! Add that to the loooong gears of the LS and I'm at a disadvantage. Oh well, gotta work with watcha got....

Raul


[Modified by sando112, 4:56 PM 6/8/2002]