800+ whp turbo motor for sale
Thread Starter
Honda-Tech Member
Joined: Dec 2004
Posts: 936
Likes: 0
From: gainesville, Va, united states
800+ whp turbo motor for sale
I am selling a complete built 2.0 turbo motor. This motor has made over 800WHP on C-16 with a 71mm turbo.
AEBS 84mm sleeves
O-ringed
Race prepped LS crank
Pauter LS rods
Oem Honda Bearings throughout
84mm10.0:1 CP pistons
Upgraded thick wall wrist pins
New OEM Acura oil pump
New OEM Acura water pump
New OEM Acura T-belt
ATI SFI approved crank pulley
Fully race ported B-16 head
84mm combustion chambers
InlinePro springs and titanium retainers
Full-Race turbo camshafts
ARP head studs
InlinePro sheet metal intake manifold port matched to head
InlinePro fuel rail
Has been 163MPH in Mat Kellers SFWD hatch
!!!!!!!!! PRICE REDUCED!!!!!!!!!! $4,500.00
Can include NX direct port (never been sprayed) seen in picture for additional $600.00 This kit retails for $900.00 not including labor to bend lines and install in intake manifold.
This is less than it would cost for the parts in this motor not including any labor, machining costs, or the stock swap needed in order to have a motor sleeved and head ported.
I purchased this motor from Brian Fisher at Inline Pro and you can contact him for any additional info and for a vouch!
Pics of motor can be seen here https://honda-tech.com/zerothread?id=1429073
Modified by allmotorh22 at 1:10 PM 2/14/2007
AEBS 84mm sleeves
O-ringed
Race prepped LS crank
Pauter LS rods
Oem Honda Bearings throughout
84mm10.0:1 CP pistons
Upgraded thick wall wrist pins
New OEM Acura oil pump
New OEM Acura water pump
New OEM Acura T-belt
ATI SFI approved crank pulley
Fully race ported B-16 head
84mm combustion chambers
InlinePro springs and titanium retainers
Full-Race turbo camshafts
ARP head studs
InlinePro sheet metal intake manifold port matched to head
InlinePro fuel rail
Has been 163MPH in Mat Kellers SFWD hatch
!!!!!!!!! PRICE REDUCED!!!!!!!!!! $4,500.00
Can include NX direct port (never been sprayed) seen in picture for additional $600.00 This kit retails for $900.00 not including labor to bend lines and install in intake manifold.
This is less than it would cost for the parts in this motor not including any labor, machining costs, or the stock swap needed in order to have a motor sleeved and head ported.
I purchased this motor from Brian Fisher at Inline Pro and you can contact him for any additional info and for a vouch!
Pics of motor can be seen here https://honda-tech.com/zerothread?id=1429073
Modified by allmotorh22 at 1:10 PM 2/14/2007
.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mr. Danieli
Classifieds: Forced Induction
1
Nov 18, 2005 03:24 PM