Complete 800+WHP B-series 2.0 FORSALE
Thread Starter
Honda-Tech Member
Joined: Dec 2004
Posts: 274
Likes: 0
From: SomeWhere, Nj/Va, U.S.A
Complete 800+WHP B-series 2.0 FORSALE
I am selling a complete built 2.0 turbo motor. This motor has made over 800WHP on C-16 with a 71mm turbo.
AEBS 84mm sleeves
O-ringed
Race prepped LS crank
Pauter LS rods
Oem Honda Bearings throughout
84mm 9:1 Arias pistons
Upgraded thick wall wrist pins
New OEM Acura oil pump
New OEM Acura water pump
New OEM Acura T-belt
ATI SFI approved crank pulley
Fully race ported B-16 head
84mm combustion chambers
InlinePro springs and titanium retainers
Comp Cams custom turbo camshafts
ARP head studs
InlinePro sheet metal intake manifold port matched to head
RPM 74mm billet throttle body matched to intake
InlinePro fuel rail
1600cc injectors
This motor was completely refreshed 1 week ago and used for the last Import vs. Domestic race at MIR. Still in Mat Keller's T4 integra and can hear run. It also trapped 155+MPH with no second gear weighing 2450 lbs.
Asking $7500.00 complete from throttle body to oil pan!!!
Can include NX direct port (never been sprayed) seen in picture for additional $700.00 This kit retails for $900.00 not including labor to bend lines and install in intake manifold.
This is less than it would cost for the parts in this motor not including any labor, machining costs, or the stock swap needed in order to have a motor sleeved snd head ported.
AEBS 84mm sleeves
O-ringed
Race prepped LS crank
Pauter LS rods
Oem Honda Bearings throughout
84mm 9:1 Arias pistons
Upgraded thick wall wrist pins
New OEM Acura oil pump
New OEM Acura water pump
New OEM Acura T-belt
ATI SFI approved crank pulley
Fully race ported B-16 head
84mm combustion chambers
InlinePro springs and titanium retainers
Comp Cams custom turbo camshafts
ARP head studs
InlinePro sheet metal intake manifold port matched to head
RPM 74mm billet throttle body matched to intake
InlinePro fuel rail
1600cc injectors
This motor was completely refreshed 1 week ago and used for the last Import vs. Domestic race at MIR. Still in Mat Keller's T4 integra and can hear run. It also trapped 155+MPH with no second gear weighing 2450 lbs.
Asking $7500.00 complete from throttle body to oil pan!!!
Can include NX direct port (never been sprayed) seen in picture for additional $700.00 This kit retails for $900.00 not including labor to bend lines and install in intake manifold.
This is less than it would cost for the parts in this motor not including any labor, machining costs, or the stock swap needed in order to have a motor sleeved snd head ported.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mr. Danieli
Classifieds: Forced Induction
1
Nov 18, 2005 03:24 PM