Cost for a shop to shave 1mm off rod

Reply Subscribe

Thread Tools

Search this Thread

Jan 24, 2005 | 02:27 PM

Resident Evo

Thread Starter

Honda-Tech Member

Joined: Sep 2002

Posts: 2,420

Likes: 0

From: wherever is clever

Cost for a shop to shave 1mm off rod

Modified by ht-si at 12:58 PM 3/1/2007

Jan 24, 2005 | 05:59 PM

_BEN_

Member

Joined: Dec 2001

Posts: 2,247

Likes: 0

From: SoCal, USA

Re: Cost for a shop to shave 1mm off rod (EBP-Si)

I dunno but you could search for posts where they put ls rods in a d series. Some of them discuss costs.

I dont think it was much.

Jan 24, 2005 | 06:34 PM

NJIN BUILDR

Honda-Tech Member

Joined: Mar 2003

Posts: 3,333

Likes: 0

From: Hudson, NH, 03051

Re: Cost for a shop to shave 1mm off rod (EBP-Si)

You are probably looking at about $30 - $40.Can be done in a bridgeport in about 15-30 minutes.Shop will probably charge you minimum shop rate.
Glenn

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

Ls rods in a d-series

alwaysbroken

All Motor / Naturally Aspirated

Jun 16, 2010 06:59 AM

machine shop help. ls rods on d series

menkio

Forced Induction

Dec 23, 2008 07:32 AM

bearing clearance problem ufdasfhodhsafjdvcasnvpdajad!!!

vtecspeed1320

Drag Racing

Jan 24, 2008 04:04 PM

rod small end width?

93preludes

All Motor / Naturally Aspirated

Nov 23, 2005 06:17 PM

Breaking a Rod?

turbo sol

Forced Induction

Mar 9, 2003 06:31 PM