Block and Head
Thread Starter
Joined: Feb 2003
Posts: 123
Likes: 0
From: edmond, ok, usa
Block and Head
This is a built h23a prelude block. It has darton sleeves with crower rods and JE pistons. The head has been fully built with ss valves and retainers. Stay tuned for more info on the engine!!! 
I'm open to offers so IM me with them, or any questions you have about the engine.
I'm open to offers so IM me with them, or any questions you have about the engine.
Thread Starter
Joined: Feb 2003
Posts: 123
Likes: 0
From: edmond, ok, usa
info on the engine:
The block had around 10k miles on it and was running very strong when it was taken out of the car. The compression is 9.0.1 for the JE turbo pistons. The rods are by crower.
*The engine made 325hp and 340 tq down in Dallas at Jotech. The power was made on a very hot day so i'm sure much more could be squeezed out. Also this power was made on 91 octane with a pretty safe tune.
The block had around 10k miles on it and was running very strong when it was taken out of the car. The compression is 9.0.1 for the JE turbo pistons. The rods are by crower.
*The engine made 325hp and 340 tq down in Dallas at Jotech. The power was made on a very hot day so i'm sure much more could be squeezed out. Also this power was made on 91 octane with a pretty safe tune.
Thread
Thread Starter
Forum
Replies
Last Post
N20civicB18
Northeast (Sales)
32
Mar 7, 2007 07:19 PM