im throwing in a b18b1 into my 98 civic si that has a d16y8 in it...I have the following parts:

motor
tranny
axles and half shaft
ECU and conversion harness
shift linkage 99-00 SIR
rear bracket 99-00 SIR
clutch and flywheel
waiting on cable conversion kit from JDM source

so is there anything else I need? I was lookin on honda-tech and they r talkin about 96-00 civics with a b18a and I would need delsol rad hoses or teg hoses, would I need to get them too??? also mounts, I hope to hell that D-series mounts would work cauze im runnin low on $$$ and was told and read all over the place that the stock mounts would work except the rear bracket

so I ask again....do I need anythin else or am I all set to swap in May which I planned?

thanks

Stu

 

ttt