Problems with my H22a swap into my EG
05-04-2005, 09:47 PM
#1
Thread Starter
Join Date: May 2005
Location: Gurnee, IL, USA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Problems with my H22a swap into my EG
hey, this is my first post here, but I have been lurking for a while...
My friend and I recently did an H22a swap into my 92 dx. For some reason we are having major problems getting the car to start. The engine turns and everything. We think we arent getting a spark, and we also think that part, or all of the wiring harness could be bad. Some of the wires are reading resistance. Does anyone know if there is supposed to be resistance? Any help would be GREATLY appreciated. I ordered the engine from HMO....but i DO NOT think the problem is the motor. Thanks in advance.
Marty
My friend and I recently did an H22a swap into my 92 dx. For some reason we are having major problems getting the car to start. The engine turns and everything. We think we arent getting a spark, and we also think that part, or all of the wiring harness could be bad. Some of the wires are reading resistance. Does anyone know if there is supposed to be resistance? Any help would be GREATLY appreciated. I ordered the engine from HMO....but i DO NOT think the problem is the motor. Thanks in advance.
Marty
05-05-2005, 05:42 AM
#2
Member
Re: Problems with my H22a swap into my EG (portnoytama)
https://honda-tech.com/zerothread?id=1171263
Don't know about resistance, but voltage is on that link about half way down the page. just remember, for it to start you need fuel, spark, compression, and timing. That's all. good luck.
Don't know about resistance, but voltage is on that link about half way down the page. just remember, for it to start you need fuel, spark, compression, and timing. That's all. good luck.
Thread
Thread Starter
Forum
Replies
Last Post
