CanuckCRX

Anybody ever drill/tap their d16z6 and mount an intermediate shaft off of a ZC to it and use equal length axles?We had an engine out of a 1994 Si the other day, and I saw the holes for a intermediate shaft...so I grabbed a ZC one I had lying around..and the holes line up. For the pass side axle you could use the stock EG axle, but for the drivers side I don't know...maybe a ZC axle..
If anyone knows, let me know, but I will play around with it and if I figure it out I will let everyone know.. At least it would cut down on torque steer..

Jay

CanuckCRX

Anyone??

oldskool_rex

seems like you would need to have two right side EG axles...only the one on the left side would have to have a different inner socket to slide into the halfshaft.


[Modified by oldskool_rex, 10:00 PM 8/20/2002]

CanuckCRX

Yeah I am going to measure up a JDM ZC left hand side axle and see if it will work or not...I don't know if the spline count is the same but I will keep trying.
Thanks

Snail Tuning

does it work?

also would the intermediate shaft and axles from an 86-89 integra work?

crxcess

I am going to pull this one back from the dead. I am wondering the same thing and haven't found an answer.

if I use the zc intermediate shaft in my eg, what left side axle would I need?