Is this Pressure Plate Still good?? HELP!!!
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2003
Location: Miramar, FL
Posts: 3,299
Likes: 0
Received 0 Likes
on
0 Posts
Is this Pressure Plate Still good?? HELP!!!
Well I bought a motor from my friend and it had an ACT HD PP (Pressure Plate) and 4 puck clutch.
I took off the clutch and PP and was inspecting everything. Im planning on replacing the 4 Puck with a full disc but i was looking at the PP and noticed that there are grooves from where the clutch grabbed the PP. The grooves arent deep.
My Question is, is the PP still any good? If not, can a shop resurface the PP. The groove isnt deep at all.
The motor has been sitting up so the middle is all rust and oxidation.
The arrows indicate where the clutch has been grabbing.
TIA
I took off the clutch and PP and was inspecting everything. Im planning on replacing the 4 Puck with a full disc but i was looking at the PP and noticed that there are grooves from where the clutch grabbed the PP. The grooves arent deep.
My Question is, is the PP still any good? If not, can a shop resurface the PP. The groove isnt deep at all.
The motor has been sitting up so the middle is all rust and oxidation.
The arrows indicate where the clutch has been grabbing.
TIA
Thread
Thread Starter
Forum
Replies
Last Post
ieatrice
Honda Civic / Del Sol (1992 - 2000)
3
07-31-2007 08:55 PM
SuicideSlide
Honda Civic / Del Sol (1992 - 2000)
11
08-29-2004 01:25 PM