Passenger CV boot is ripped on my civic, need installation guide/help?
#1
Honda-Tech Member
Thread Starter
iTrader: (1)
Join Date: Feb 2007
Location: Snohomish County, WA
Posts: 3,683
Likes: 0
Received 0 Likes
on
0 Posts
Passenger CV boot is ripped on my civic, need installation guide/help?
My 97 civic ex has the passenger cv boot ripped open. I noticed this while I was installing my Skunk2 Coilovers. I can buy the CV axles for the passenger and driver (driver's one is cracked and getting ready to go) but I need an installation guide or manual that can tell me how to replace and install.. Never done it before and I sure don't want to pay money to get this fixed. I heard it's not too hard.
#2
Honda-Tech Member
Re: Passenger CV boot is ripped on my civic, need installation guide/help? (ke98248)
Nope, not that bad at all.
These are the instructions for the EG, but it's the same concept, also you don't always have to unbolt the ball-joint. I prefer to unbolt everything on the LCA except the LCA.
These are the instructions for the EG, but it's the same concept, also you don't always have to unbolt the ball-joint. I prefer to unbolt everything on the LCA except the LCA.
#3
Honda-Tech Member
Thread Starter
iTrader: (1)
Join Date: Feb 2007
Location: Snohomish County, WA
Posts: 3,683
Likes: 0
Received 0 Likes
on
0 Posts
Re: Passenger CV boot is ripped on my civic, need installation guide/help? (dr_latino999)
Thank you! I will take a closer look at it and see if I can't get it done. Thanks again!
Thread
Thread Starter
Forum
Replies
Last Post
barney510
Honda Civic / Del Sol (1992 - 2000)
3
03-03-2006 04:31 PM