PunchedGuava

Hello. I've recently had some function and form type 1's installed on my 2000 ex. A couple days later I wanted to adjust the rear height so when I jacked up the rear, I noticed something very strange. From where the coilover connects to the real control arm,on the rear side, the screw looked as if it's missing a nut... Is that normal? Do these coilovers have some kinda built in nut, tread kinda thing going on? I tried to loosen the screw to check but it's in there pretty tight and I don't have a air gun to loosen it.

Here's a pic:

http://www.4gp.tw/b013/1365979329123.jpg

grumblemarc

iTrader: (4)

How would you not know if you installed them? Did you not compare them to the other side?

PunchedGuava

Sorry, I will rephrase that. I had a friend of a friend do them. I apologize for the confusion and will edit the OP

grumblemarc

iTrader: (4)

The nut looks threaded. To confirm all you have to do is look at the other side of the car.

PunchedGuava

Both sides look the same. Or, do you mean the front of the arm where the screw enters or the rear side of the arm.. Which I've posted a picture of?

98civdx

It's not missing anything. Although it doesn't look like a nut, it is.

PunchedGuava

Thank you guys, peace of mind achieved for the time
Being... On to fix my exhaust rattling against the heat shield...

azzazel_9

Yea that hole there is threaded i suppose if you wanted to put your mind at ease you could put a nut on there but it isn't needed