CEL 41, 8, and 9
#1
Honda-Tech Member
Thread Starter
Join Date: Nov 2008
Location: Milwaukee, WI, USA
Posts: 127
Likes: 0
Received 0 Likes
on
0 Posts
CEL 41, 8, and 9
Hey everyone,
So I finally swapped out my p06 for a p28 after I swapped in a z6. I drove the car since December without any problems. After putting in the p28, I started getting a CEL 41 for the o2 sensor heater... from what I've read it's like a loose wire somewhere since I just replaced the o2 sensor.
However, tonight I was driving around and then codes 8 and 9 started flashing. These indicate the Top Dead Center sensor and cylinder sensor. What would cause these to all of a sudden pop up after driving just fine for 5 months?
So I finally swapped out my p06 for a p28 after I swapped in a z6. I drove the car since December without any problems. After putting in the p28, I started getting a CEL 41 for the o2 sensor heater... from what I've read it's like a loose wire somewhere since I just replaced the o2 sensor.
However, tonight I was driving around and then codes 8 and 9 started flashing. These indicate the Top Dead Center sensor and cylinder sensor. What would cause these to all of a sudden pop up after driving just fine for 5 months?
Thread
Thread Starter
Forum
Replies
Last Post
santanach
Acura Integra
1
05-19-2008 04:02 PM