Brake booster/Master Cylinder questions
#1
Brake booster/Master Cylinder questions
So I have have a 93 Civic CX that the previous owner did a rear disc conversion on.
I'm replacing the brake master cylinder as well as the brake booster since they are stock and are faulty =(. I picked up new Integra RS booster and master cylinder.
I have the booster on and am attempting to install the master cylinder. When I push it on to the booster it isn't flat against the booster, there is maybe half inch to an inch gap.
My question is, is this normal and tightening down the nuts will "force" it in place? Or is there something that I am missing?
I'm replacing the brake master cylinder as well as the brake booster since they are stock and are faulty =(. I picked up new Integra RS booster and master cylinder.
I have the booster on and am attempting to install the master cylinder. When I push it on to the booster it isn't flat against the booster, there is maybe half inch to an inch gap.
My question is, is this normal and tightening down the nuts will "force" it in place? Or is there something that I am missing?
Thread
Thread Starter
Forum
Replies
Last Post
wwhitby
Honda Civic (2001 - 2005)
2
02-27-2017 02:28 AM
integra123
Honda Civic / Del Sol (1992 - 2000)
5
08-08-2006 05:52 PM