B16a Knocking.... HELP?
#1
Honda-Tech Member
Thread Starter
Join Date: Jul 2006
Location: Cleveland, OH
Posts: 467
Likes: 0
Received 0 Likes
on
0 Posts
B16a Knocking.... HELP?
Good evening (morning )
I bought a B16a swap from HMO and after 200 miles am currently experiencing a knocking. I replaced the rod beairngs which were chewed up. #3 bearings were WASTED while the others were a little blued but not bad.... REAPLCED ALL ROD BEARINGS. Started it up and an initial knock..... let it warm to operating temp then held at 2500 rpms for 1 minute. Now i still have a knock at startup... about 9 or 10 rapid knocks, then it dissappears and stabilizes an idle. Give it half throttle and it knocks but NOT at 0 or 100% throttle. Im lost at this point, is it in my best interest to pull the block.....? the crank journal was in spec and it plastigauges out within spec as well.
thankjs
dan
I bought a B16a swap from HMO and after 200 miles am currently experiencing a knocking. I replaced the rod beairngs which were chewed up. #3 bearings were WASTED while the others were a little blued but not bad.... REAPLCED ALL ROD BEARINGS. Started it up and an initial knock..... let it warm to operating temp then held at 2500 rpms for 1 minute. Now i still have a knock at startup... about 9 or 10 rapid knocks, then it dissappears and stabilizes an idle. Give it half throttle and it knocks but NOT at 0 or 100% throttle. Im lost at this point, is it in my best interest to pull the block.....? the crank journal was in spec and it plastigauges out within spec as well.
thankjs
dan
Thread
Thread Starter
Forum
Replies
Last Post
strictly.business
All Motor / Naturally Aspirated
14
05-08-2007 06:45 PM