CV Axle Installation - 94 Accord EX VTEC
#1
Junior Member
Thread Starter
CV Axle Installation - 94 Accord EX VTEC
First post all! I recently puchased a 94 accord to supplement my 2007 JK Unlimited... mainly to keep the miles of the jeep, the wear off the 35's, a to have a daily driver.
Either way... i picked up this accord on a salvage/repaired title for 800.00 bucks. Strong motor, decent transmission, and minor front end damage.
The questions:
I searched and pulled the thread on CV installation... got it out... and was able to push it in until the c clip engaged. However, there is still a good portion that will not go in (ie: seal up with the tran seal)... I have read some posts about a rubber mallet... i tried this but was rather timid as I did not want to break anything... how much hammering are we talking about here?
Transaxle-seal replacement: How difficult?? Just pull the axle, pull the seal and install a new one?
Thanks in advance!
Either way... i picked up this accord on a salvage/repaired title for 800.00 bucks. Strong motor, decent transmission, and minor front end damage.
The questions:
I searched and pulled the thread on CV installation... got it out... and was able to push it in until the c clip engaged. However, there is still a good portion that will not go in (ie: seal up with the tran seal)... I have read some posts about a rubber mallet... i tried this but was rather timid as I did not want to break anything... how much hammering are we talking about here?
Transaxle-seal replacement: How difficult?? Just pull the axle, pull the seal and install a new one?
Thanks in advance!
Thread
Thread Starter
Forum
Replies
Last Post
Lynn Porter
Honda Accord (1990 - 2002)
1
08-11-2015 10:29 PM
1994, 93, 94, accord, axle, axleinstallation, axleinstallion, cv, cvaxel, hammering, honda, install, installation, seal, transaxle