T25, Accord, SAFC -- a few questions
#1
Honda-Tech Member
Thread Starter
Join Date: Jul 2003
Location: The Zoo,, MI, USA
Posts: 3,180
Likes: 0
Received 0 Likes
on
0 Posts
T25, Accord, SAFC -- a few questions
As some of you may know, I recently purchased accord94dx's car. I am going to take it to payn when they finally get back to me, but I had a few questions first.
First, the setup:
DSM 450CC injectors and the SAFC. SAFC settings are lo throttle = 46% high throttle = 48% (i THINK, they are close to that)
LoThr Fuel Map is = -32 to -36 on, the ECU advances timing under part throttle, so I kept it rich under part throttle settings too.
HiThr Fuel Map is also -32 to -36 across the rev range.
Timing is knocked back 2 degrees.
Its an HKS kit with a t25 snail and a modified drag3 fmic. Car runs 6-7psi, 94 accord dx (non vtec).
The setup feels like it bogs a little at wot. Basically, the car is just too rich at 11:1. I want payn to lean it out a little, but I'm also concidering pumping the boost up a bit. No one would happen to have a compressor map, would they? I'm just not sure what the effeciency range of such an incredibly small snail would be on this setup.
So can any one give me a decent idea of what maybe to try in the mean time, what to expect from payn, and how much boost to run on this snail? Thanks!
First, the setup:
DSM 450CC injectors and the SAFC. SAFC settings are lo throttle = 46% high throttle = 48% (i THINK, they are close to that)
LoThr Fuel Map is = -32 to -36 on, the ECU advances timing under part throttle, so I kept it rich under part throttle settings too.
HiThr Fuel Map is also -32 to -36 across the rev range.
Timing is knocked back 2 degrees.
Its an HKS kit with a t25 snail and a modified drag3 fmic. Car runs 6-7psi, 94 accord dx (non vtec).
The setup feels like it bogs a little at wot. Basically, the car is just too rich at 11:1. I want payn to lean it out a little, but I'm also concidering pumping the boost up a bit. No one would happen to have a compressor map, would they? I'm just not sure what the effeciency range of such an incredibly small snail would be on this setup.
So can any one give me a decent idea of what maybe to try in the mean time, what to expect from payn, and how much boost to run on this snail? Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
93TurboSi
Forced Induction
4
04-13-2004 08:29 AM
99lspwr
Forced Induction
32
02-04-2004 04:45 AM