Will the sc61 fit a drag manifold without having to grind a lot of the block? Anybody running this setup? What about a GT35?


Modified by tthame1 at 2:04 PM 3/18/2004

 

Bump

 

you would have to grind but overall its just going ot be like any t04e base compressor housing.

 

I don't mind grinding, I just don't want to grind the **** out of the block

 

you have to cut a pretty decent amount but not more than any other t04e based compressor housing

 

Actually, it took me about 90 seconds with a file to shave what I needed to shave. The whole B18C1 (or B16, etc) part of the block doesn't hit, but the webbing does. I only had to shave a bit of the horizontal webbing, shaved VERY little off. B16's require more shaving than B18's.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by MadCow &raquo;</TD></TR><TR><TD CLASS="quote">Actually, it took me about 90 seconds with a file to shave what I needed to shave. The whole B18C1 (or B16, etc) part of the block doesn't hit, but the webbing does. I only had to shave a bit of the horizontal webbing, shaved VERY little off. B16's require more shaving than B18's.</TD></TR></TABLE>

Couldnt agree more! that turbo is so nice on his car too.
Shouldnt take but a few minutes and minimal grinding and measuring before she fits just fine!