RS machine PTW with a JRSC
#1
Member
Thread Starter
Join Date: Oct 2004
Location: The Burn, NY, USA
Posts: 2,152
Likes: 0
Received 0 Likes
on
0 Posts
RS machine PTW with a JRSC
Just wondering what I should set my PTW clearances at when running a JRSC with RS machine ITR replica pistons.
Ive searched and came up with .0015"-.0018" but those seem alil tight for an FI application.
I tried to contact RS but the phone # has been disconnected, I emailed too but dont have much time to hear back. Any help is greatly appreciated
Just for the record this was much easier with my JE pistons on my old turbo GSR
Ive searched and came up with .0015"-.0018" but those seem alil tight for an FI application.
I tried to contact RS but the phone # has been disconnected, I emailed too but dont have much time to hear back. Any help is greatly appreciated
Just for the record this was much easier with my JE pistons on my old turbo GSR
#2
Honda-Tech Member
Join Date: Feb 2006
Location: East Bay, CA, USA
Posts: 1,524
Likes: 0
Received 0 Likes
on
0 Posts
Re: RS machine PTW with a JRSC
RS pistons are cast aluminum not forged like JE, CP etc. Cast pistons expand very little that is why you do not need such a large PTW clearance. .0015" will be fine.
Thread
Thread Starter
Forum
Replies
Last Post
JDMCRX
Classifieds: Forced Induction
9
01-17-2011 05:02 PM
Mikeman191
Forced Induction
1
09-22-2003 03:42 PM