its almost done...after 5 months of anticipation, its almost there...need to change the drivers side spindles with new spindles w/extended wheel studs but damn axle nut wont come loose Only thing left other than tuning....Enjoy!! Any feedback good or bad appreciated!!!

 

That is a NICE looking setup.

 

THANKS!!!!!

 

i like a lot..good job

 

is that 13 or 15inch slicks

 

13" slicks but i think i'm having a lil problem

 

very nice. what are the dimensions on the IC

 

What are the specs of the motor?

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by g2turbo &raquo;</TD></TR><TR><TD CLASS="quote">very nice. what are the dimensions on the IC</TD></TR></TABLE>

The intercooler looks to be around 30x11x3.

 

what set up are you runing.

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by PRojectSi2 &raquo;</TD></TR><TR><TD CLASS="quote">13" slicks but i think i'm having a lil problem </TD></TR></TABLE>

What is the exact size of your slicks ? and what's the problem ?

 

thanks guys!!!

i/c is an Apexi Skyline GTR core

motor specs:
B16a
JE 9.0:1
Crower Rods
Nuformz Blockguard

i have another motor ready to go but I'm gonna see how far I can push this 1.6!!

 

Very nice set up! I like Si s in white too! Nice paint job!

 

my slicks are 24.5x8x13... i dont think its the slicks though...i think it might be the wheel...i dunnoo

 

thanks!!! kinda sucks...i had this car painted white about 1 yr ago...but now SFP has the same thing same color

oh well maybe graphics will set it off for the '04 season

 

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by PRojectSi2 &raquo;</TD></TR><TR><TD CLASS="quote">thanks guys!!!

i/c is an Apexi Skyline GTR core

motor specs:
B16a
JE 9.0:1
Crower Rods
Nuformz Blockguard

i have another motor ready to go but I'm gonna see how far I can push this 1.6!! </TD></TR></TABLE>

B16A can make some power too! See sig

 

stock bore??
what turbo??

info please please!!!

 

84mm bore 10.2:1 CR and Full Race manifold, 3" DP and Full Race T67 turbo .68 A/R tangential turbine housing with P trim wheel.

 

and thats the setup u pulled 500+ on ???

what managment are u running??

 

Hondata STage 2B old school Hondata.

 

hmm ok....what size injectors???

'm just trying to figure out what should i tune my car to and what its capabe of

 

Eric, car is looking awesome. I'm sure you'll see 350whp or better.

 

HOLY SHYT! That FMIC is huge! Can't wait to see numbers!

 

Nice got pic's of the mani and turbo? Good job with the heat wrap

 

the axel nut will come loose... get someone to step on the brakes, and you jump on a breaker bar