i need help with piston setup
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2007
Location: SaC tOwN 916, UsA
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
i need help with piston setup
im wondering if Mahle pistons are an good in a 81.50mm stock sleeve B18c1 block..
cause i just bought some 81.50mm 9-1 comp from here.....i never seen anyone use these on here..i always see ( je, cp, weisco, etc...)
because i got a deal on them thats why i bought it.....so i just wanna know if their any good with stock sleeves and Eagle rods......im looking to make around 300hp....
b18c1 stock sleeve 81.50mm
mahle pistons 9-1 comp
Eagle rods
stock crank
b16a2 head
AEM camgears
01 Itr cams
JG edelbrock manifold
65mm TB
fuel rail w/ FPR
b16a2 tranny
stock clutch ( for now...will get stage 4 CM and 12lb flywheel...)
t3/t4 turbonetics 57 trim
cast iron manifold
38mm delta mark II
2.5 DP....and y cutout
2.5 charge pipes
HKS BOV
FMIC
fastturbo vacum box
XS manuel boost controller
running on chrome
p28
thankss
cause i just bought some 81.50mm 9-1 comp from here.....i never seen anyone use these on here..i always see ( je, cp, weisco, etc...)
because i got a deal on them thats why i bought it.....so i just wanna know if their any good with stock sleeves and Eagle rods......im looking to make around 300hp....
b18c1 stock sleeve 81.50mm
mahle pistons 9-1 comp
Eagle rods
stock crank
b16a2 head
AEM camgears
01 Itr cams
JG edelbrock manifold
65mm TB
fuel rail w/ FPR
b16a2 tranny
stock clutch ( for now...will get stage 4 CM and 12lb flywheel...)
t3/t4 turbonetics 57 trim
cast iron manifold
38mm delta mark II
2.5 DP....and y cutout
2.5 charge pipes
HKS BOV
FMIC
fastturbo vacum box
XS manuel boost controller
running on chrome
p28
thankss
Thread
Thread Starter
Forum
Replies
Last Post
95IntegraGSRAZ
Forced Induction
16
01-26-2004 03:59 PM
EKweezy
Honda Civic / Del Sol (1992 - 2000)
18
07-05-2003 04:53 PM