JRSC ITR ok time?
#1
Honda-Tech Member
Thread Starter
JRSC ITR ok time?
i went to the strip yesterday and ran a 13.59 on my setup. I have a JRSC with methanol, header, stock intake with K&N filter and thermal 2.5 exhaust. i am putting down 250 to the wheels. this was with full interior with spare wheel etc. and drag radials on the stock USDM 15 x 5.5 inch wheels also.
My 1/4 mile was 13.59
60ft 2.219 i believe (dont have slip in front of me)
trap speed 104._
Is this an ok time? What should I be running and if anyone has any input on what they have ran on their JRSC setup would be greatly appreciated so I know what to shoot for.
I will be putting back on my thermal 3" and doing a bpi stack intake with samco hose before i go again. will see if i get any diff times.
Thanks
i hope that it is enough info
My 1/4 mile was 13.59
60ft 2.219 i believe (dont have slip in front of me)
trap speed 104._
Is this an ok time? What should I be running and if anyone has any input on what they have ran on their JRSC setup would be greatly appreciated so I know what to shoot for.
I will be putting back on my thermal 3" and doing a bpi stack intake with samco hose before i go again. will see if i get any diff times.
Thanks
i hope that it is enough info
#4
Honda-Tech Member
Thread Starter
Re: JRSC ITR ok time? (gosu08)
i found my exact time slip
R/T .443
60ft 2.182
330 5.878
1/8 8.868
mph 82.47
1000 11.429
1/4 13.598
trap mph 104.26
adding in a bpi stack intake with samco hose and putting back on my thermal 3" intake, what do you all think i can hit?
im going to the track this friday and sunday for car shows.
thanks for al your help and responses
R/T .443
60ft 2.182
330 5.878
1/8 8.868
mph 82.47
1000 11.429
1/4 13.598
trap mph 104.26
adding in a bpi stack intake with samco hose and putting back on my thermal 3" intake, what do you all think i can hit?
im going to the track this friday and sunday for car shows.
thanks for al your help and responses
#5
Honda-Tech Member
Thread Starter
Re: JRSC ITR ok time? (gosu08)
any tips on launching to lower my 60'?
ive been lauching at 4k then when the first yellow light comes on ive been slowly revving it up till i finally go. my final rpm is about 5k-5.5k. any ideas on what i should do different or tips would be greatful.
thank you
ive been lauching at 4k then when the first yellow light comes on ive been slowly revving it up till i finally go. my final rpm is about 5k-5.5k. any ideas on what i should do different or tips would be greatful.
thank you
Thread
Thread Starter
Forum
Replies
Last Post