jdmcx

i was just wondering what the spring pressure is for the following:-
skunk2
toda
crower
JG (engine dynamics)
jun
manley
just for comparison

Matty.

Just did the Todas.

195 lbs @ 12.0mm lift.

My JGs = 263 lbs. @ 12.0mm lift

I have the Juns but forgot to bring em to the test.

Rocket

The specs listed on Skunks site is accurate for their springs. I've benched tested them.

gsrswapdcivic

Jesus Christ man I have my head at some dumb *** shop that work solely on V8 crap and have never seen a Integra. I have been in a jumble with them over this for a while on the install height and pressure. the press. specs on skunk2's site are right but I could not find an install height. i have the manuels from acura but the only give a free height fer. if any one can tell me exactly what the height is i would be very greatful (height for installing skunk2 valve springs in a 95 GSR)

Jasper_db1

Doesn't Skunk offer any support?

asubennett

I just dealt with this with skunk springs. install them @ 1.330. With their retainer it leaves me about .040 until coil bind @ 12.5mm lift with my Toda C's and spring pressure is right on with what Skunk calls for.