Suggestions needed: assistance in ID'ing aftermarket B-series camshafts
#1
Suggestions needed: assistance in ID'ing aftermarket B-series camshafts
I bougth a b16a2 from an junkyard. Head was sligthly ported, some aftermarket springs and some cams.
The intake cam have a stamp of 0 ore o
Base circle is
29.7mm
Lobe lifts (mm) on The intake cam, measured with manual caliper so +-0.05mm tolerance.
Pri. 34.50 (4.80)
Mid. 37.35 (7.65)
Sec. 35.80 (6.1)
The intake cam have a stamp of 0 ore o
Base circle is
29.7mm
Lobe lifts (mm) on The intake cam, measured with manual caliper so +-0.05mm tolerance.
Pri. 34.50 (4.80)
Mid. 37.35 (7.65)
Sec. 35.80 (6.1)
#2
Re: Suggestions needed: assistance in ID'ing aftermarket B-series camshafts
Something is up with the measurements, maybe the base circle # is off? I don't think even the auto b16a had that little of lift.
Any more pics?
Any more pics?
Thread
Thread Starter
Forum
Replies
Last Post
JDM-JAMES
Honda Civic / Del Sol (1992 - 2000)
3
09-19-2010 05:01 PM