Topdawgg

Walkin someone through it.. from the crank, right up to the cams... assembling everything?

Im curious to see a video like that, with someone explainin as they go through

xDicktonesx

yea. intertune tv. its an in car rebuild but he gets 206whp out of an oem bottom end 1595cc b16. doesnt pull the crank, doesnt hone the cylinder walls. i think intertune sponsors this forum

Combustion Contraption

http://www.intertune.tv

r.p.m

Here is a nice one

Eg6 Brazil Motor Build up !!!

http://the-honda-club.de/felipe/montagemdovti.wmv

And here are videos of driving/racing the car

http://the-honda-club.de/felipe/apulmao.wmv

http://the-honda-club.de/felipe/Asp201mts.wmv
(best time 1/8 mile with tranny problems 8,8 sec)

http://media.putfile.com/Civic-JUN-Vs-480HP-RS4

Mods:

AEM Cold Air Intake
S2000 TBI
Type R Intake Manifold
Hayame Fuel Rail
S-Max Fuel Regulator
Precision 680cc Injectors
Custom Intake Manifold Gasket
OEM Prelude Resistor Box
AEM Cam Pulleys
AEM Under Pulleys
AEM ECU
TODA Timing Belt
JUN Stage 3 Cams
JUN Springs
JUN Retainers
JUN Pistons 11.6 Compression Ratio
JUN Rods
JUN Crank Shaft
JUN Flywheel
JUN Exhaust Manifold
JUN Shift Bar Rubbers
MSD HVC
MSD SCI
MSD Distribuiltor Cap
Calico Bearings
Cusco LSD
C&R Radiator
Tenzo R Rear Strut Bar
Revolution Cat Back
Suspension Tokiko Ilumina Shocks and Eibach Springs
Z10 Traction Bar
Spoon wheels
Buddy Club Shift ****
Toyo T1R 195/50/15

MaGoodc2

That was one of the coolest vids I have seen in awhile

Alchemist

Theres a step by step thread on http://www.evans-tuning.com

robbieshonda

http://www.evans-tuning.com/tech1.html here you go