Transmission Problems
So, I get my swap done, just a direct JDM B18 into my DA9...
Well I get the car on the ground, get the clutch adjusted and take off, make it 20 feet (10 of which I just rolled)
Well I put it in first and take off normally...get to about 4k rpm and shift to second then REV POP and the car stops moving, now I am at a loss what it is.
The clutch feels the same.
The throwout bearing and everything is new.
Can it be the halfshafts>
Im at a loss here.
Well I get the car on the ground, get the clutch adjusted and take off, make it 20 feet (10 of which I just rolled)
Well I put it in first and take off normally...get to about 4k rpm and shift to second then REV POP and the car stops moving, now I am at a loss what it is.
The clutch feels the same.
The throwout bearing and everything is new.
Can it be the halfshafts>
Im at a loss here.
Thread
Thread Starter
Forum
Replies
Last Post
OttomanK20
Acura RSX DC5 & Honda Civic EP3
2
Jul 4, 2017 12:43 AM
RACINTWEEK
Tech / Misc
3
Feb 28, 2007 03:27 PM



