Integra Clutch pressure issue with bleeding issue
#1
Honda-Tech Member
Thread Starter
Integra Clutch pressure issue with bleeding issue
This is a 1999 integra ls if it matters.. I'm having issues with bleeding the clutch after changing the clutch master cylinder. I have tried all the methods and suggestions I have found online. Nothing comes out when I am trying to bleed it at the csc valve . I adjusted the new cms to match the distance of the stock one. What am i doing wrong.
The methods I used were vaccum pump. Person assisting me while I opened bleeder. Self bleed technique like the youtube ericthecarguy did..
is it a bad clutch slave cylinder?
The methods I used were vaccum pump. Person assisting me while I opened bleeder. Self bleed technique like the youtube ericthecarguy did..
is it a bad clutch slave cylinder?
#4
Honda-Tech Member
Join Date: Jul 2013
Location: sleeping in a 368k 95 gs-r
Posts: 1,975
Likes: 0
Received 41 Likes
on
41 Posts
Re: Integra Clutch pressure issue with bleeding issue
did you hold the pedal down while bleeding?
pre-bleed the master cylinder?
i forgot to do the latter so spent a good hour pumping/bleeding
before getting decent results.
loosen locknut c and spin it to the end of the thread
then keep turning with a wrench til pedal contacts clutch switch.
http://s23.postimg.org/ssyc5zwk9/page0334.jpg
pre-bleed the master cylinder?
i forgot to do the latter so spent a good hour pumping/bleeding
before getting decent results.
loosen locknut c and spin it to the end of the thread
then keep turning with a wrench til pedal contacts clutch switch.
http://s23.postimg.org/ssyc5zwk9/page0334.jpg
#5
Honda-Tech Member
Thread Starter
Re: Integra Clutch pressure issue with bleeding issue
Since it has snowed I think I'm just taking it to the shop.. but it could be the way I bench bleeded.. but one hour without bench bleed I didn't think it would be that long.. thanks again for your help
Thread
Thread Starter
Forum
Replies
Last Post