evo

Where can I get o-ring to fit DSM injector into B16A, has any rings from others car or other Honda fit??

92SiB18C1

Are you talking about the ring that goes inside the block? If that the case then you can use your honda one. Just take it out. Trim it a lil, just a lil to fit over the DSM or you'll have a vaccumm leak. So take off a lil, try on the injector, then take off a lil more.

dfoxengr

goto napa they have injector seal kits

evo

I try thanks

evo

Just installed 390cc DSM injectors it started at 1st time then stall never start again, what could it be?? (everything run prefect before install)

I'm runnng Mugen prog chip, stock fuel pump.

thanks

evo

Just installed the DSM 390cc injectors it started at 1st time then stall never start again. It has Mugen chip and stock fuel pump.

Anything to do with the fuel pump because not enough pressure?? (it was OK with stock injectors).
Any idea??

Jeff C

What are you using to take out the extra fuel that the injectors are supplying?

evo

b16a with CTR piston, JUNIII, mugen HQ, FPR, VAFC etc...
Would the car too rich that's why the car wouldn't start??

Jeff C

What do you the afc settings at? What -%?

evo

I set at 0% initally then reduce to 10% then 20% still not start, by the way i've got the stock fuel pump, should I upgrade the fuel pump to 250l/hr??

dfoxengr

u need to reduce to -31% and upgrade fuel pump


[Modified by hybridvteceg, 5:09 PM 4/2/2003]

lsvtecvx

Evo, did you wire in the resistors? what year is your car

evo

My car is JDM EF9 OBD0 I guess they're plug + play, rite?