thrust washer question
#1
Thread Starter
Join Date: May 2002
Location: Toronto, Ontario, Canada
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
thrust washer question
When installing the thrust washer, do the grooves face towards each other or away from each other??
I did a seach and all I came up with is: "the grooves facing toward the crank." (which I don't quite understand )
Here's the original thread: https://honda-tech.com/zerothread?id=260947
I did a seach and all I came up with is: "the grooves facing toward the crank." (which I don't quite understand )
Here's the original thread: https://honda-tech.com/zerothread?id=260947
#3
Thread Starter
Join Date: May 2002
Location: Toronto, Ontario, Canada
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
Re: thrust washer question (IN VTEC)
yes, I know the grooves face "towards the crank" already. Maybe I should re-state my question:
There are 2 thrust washers. Each thrust washer has 2 sides (1 grooved, 1 non-grooved). Now when the thrust washers are in place, will the grooves on one thrust washer be facing the the grooves on the other thrust washer, or not?
There are 2 thrust washers. Each thrust washer has 2 sides (1 grooved, 1 non-grooved). Now when the thrust washers are in place, will the grooves on one thrust washer be facing the the grooves on the other thrust washer, or not?
#5
Junior Member
Join Date: Jul 2001
Location: bay area, california
Posts: 214
Likes: 0
Received 0 Likes
on
0 Posts
Re: thrust washer question (CRXGSR)
when the thrust washer(s) are installed, the smooth side of the thrust washer will go against the block(inward), and the grooved side will go against the thrust surface on the crank(outward). when both are installed, the groove side will face away from each other
Thread
Thread Starter
Forum
Replies
Last Post
juntuned
All Motor / Naturally Aspirated
57
09-29-2006 05:33 PM