curt207

ok i recently started a swap hince title. but im lost on bits n pieces of it. im getting a p14 ecu with jumper since the prelude is 97 with obd2 wiring harness.
i know i need to rewire the distrubitor, crankshaft sensor, and injectors. also know i need custom mounts. but idk how to rewire everything right n the guy thats helping me aint around enough to get it done in the time i need it. can anybody give me a dummys way to do all this and let me know of any other problems i might run into

mygoldeneg

p14 ecu is for a h23nonvtec motor

curt207

yea but i plan on mapping it to my motor

curt207

ok ive got the ecu in and going buti still have the rewiring to do. does any1 know if some1 makes a conversion carness for all the rewiring im going to need to do instead??

grumblemarc

iTrader: (4)

Amazing. Did you not think of any of this beforehand?

Check the FAQ in the Hybrid section.

curt207

well i was kinda in a hurry n made the stupid mistake of buying the full 97 prelude out the scrapyard that way i have the entire swap right there n if i needed anything it was there. but the bolts in my dd integra motor mount broke off inside the motor n it cost to much to get them drilled out n i dont want to drill it cause its to high risk that i f* up the motor by drilling to deep or missing n cracking the block. so its been kinda fix each problem as it comes along then look for new one that might happen.

grumblemarc

iTrader: (4)

What does the wiring have to do with broken bolts? Check the FAQ in the Hybrid section.
Click this link!!! -----------> Hybrid What works? What isn't practical?

curt207

broken bolts was the start of my problems leading up to the wiring issue. n thanks for the tread, but not many are any help

curt207

ive come up with a good question. the motor and wiring harnes ive got are both obd2 but im using a jumper harness from the computer to the wiring harness. with both the motor and wiring harness being obd2 shouldnt the jumper harness repin the ecu to where i dont have to rewire the distrubitor and crankshaft sensor?

curt207

ok ive got the motor in. radiators proving a tight fit. but my main concern is wiring up the rest of the car. should i rewire the entire thing or just cut n splice. i know rywire does a conversion for something like this but i havent been able to find it. any help?

Farva83

Did anyone have a recommend engine mount brand for h22a4 swap into 94 Integra? I've read up on a few it seems they put the engine in different spots between the brands.